Is the beam operating within elastic limits (yield strain for steel ≈ 0.0015)? True or False

Question

BlackTom AI · Accepted Answer

The question asks whether the beam is operating within elastic limits, given a yield strain for steel of approximately 0.0015.

Option 1: True. This would be correct if the actual strain in the steel of the beam is at or below the yield strain of ~0.0015, meaning the material has not yet yielded and remains in the elastic portion of the stress–strain curve. In this case, any deformation is reversible and the stress stays within the elastic limit. The statement is therefore conditionally true, contingent on the measured or calculated strain being ≤ 0.0015.

Option 2: False. This would be correct if the beam experiences strains exceeding the yield strain of ~0.0015, indicating yielding has occurred and plastic deformation is taking place. In such a scenario, the material has left the elastic region, and the response includes permanent deformation beyond the elastic limit. Therefore, the claim of operating within elastic limits would be incorrect when the strain exceeds the yield value.

Key concept linkage: The determination hinges on the comparison between the actual strain in the steel and the yield strain (≈0.0015). If the strain is less than or equal to the yield strain, the beam is within the elastic regime; if it surpasses it, plastic deformation begins. Without numerical strain or stress data for the beam, you cannot definitively label the state as elastic or plastic, so both options are logically possible depending on the actual values.

Additional considerations: In practice, you would check the maximum principal strain or the equivalent plastic strain in the steel. If you have geometric or load data, you could compute the bending strain at critical sections and compare to 0.0015 to decide. If a stress–strain curve or material model is given, you could determine whether the operating point lies on the linear elastic portion. If the problem provides a factor of safety or explicit stress values, convert those to strain via Hooke’s law (ε = σ/E) for steel to confirm elastic behavior. If the calculated ε ≤ 0.0015, the statement would be true; if ε > 0.0015, it would be false.

MENG-4089-06/MENG-5072-01/MENG-5072-01D Strain Measurements of a BEAM

Is the beam operating within elastic limits (yield strain for steel ≈ 0.0015)? True or False

查看解析

登录即可查看完整答案

类似问题

In a consumer society, many adults channel creativity into buying things

Economic stress and unpredictable times have resulted in a booming industry for self-help products

People born without creativity never can develop it

A product has a selling price of $20, a contribution margin ratio of 40% and fixed cost of $120,000. To make a profit of $30,000. The number of units that must be sold is: Type the number without $ and a comma. Eg: 20000

Which of the following statement regarding cost is correct:

Under the assumptions used in cost-volume-profit analysis, as the activity increases:

The CVP and break-even analysis are supported by a range of important assumptions. Which of the following is not an assumption of the CVP:

The break-even point is that at which:

更多留学生实用工具

考试浏览器助手

风格化写作助手

论文查重助手

文献引用助手

课堂转译助手

课堂笔记助手

Quiz搜索助手

学校历年真题

智能刷题助手

智能匹配练习

希望你的学习变得更简单